Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO RECEIVER › from 2013.11
RM30B0U _56 Audio / Visual / Telematics _009403 AUDIO / VIDEO _0058384 RADIO RECEIVER A

AUDIO / VIDEO  RADIO RECEIVER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL STEREO COMPONENT TUNER ASSEMBLY (w/ Satellite Radio)

Hide 2.INSTALL NO. 1 RADIO BRACKET

a.

for Radio Receiver Type, for Radio and Display Type:

i.

Install the No. 1 radio bracket with the 3 screws.



b.

w/ Satellite Radio:

i.

Install the No. 1 radio bracket with the 5 screws.



Hide 3.INSTALL NO. 2 RADIO BRACKET

a.

for Radio Receiver Type, for Radio and Display Type:

i.

Install the No. 2 radio bracket with the 3 screws.



b.

w/ Satellite Radio:

i.

Install the No. 2 radio bracket with the 5 screws.



Hide 4.INSTALL WIRE HARNESS (w/ Satellite Radio)

Hide 5.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY (for Radio and Display Type, w/ Satellite Radio)

a.

Connect each connector.


b.

Attach the 4 clips to install the radio and display receiver assembly with bracket.


c.

Install the 4 bolts.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 6.INSTALL RADIO RECEIVER ASSEMBLY (for Radio Receiver Type)

a.

Connect each connector.


b.

Attach the 4 clips to install the radio receiver assembly with bracket.


c.

Install the 4 bolts.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 7.INSTALL TELLTALE LIGHT ASSEMBLY

Hide 8.INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 9.INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 10.INSTALL CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION