Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › from 2013.11
RM30B0U _56 Audio / Visual / Telematics _009009 NAVIGATION / MULTI INFO DISPLAY _0104226 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Navigation Voice Circuit  


DESCRIPTION

This circuit is used when the voice guidance in the navigation system is on or an incoming cellular phone voice in the "Bluetooth" hands-free system is heard.

Using this circuit, the navigation receiver assembly sends the signals to the stereo component amplifier assembly.

WIRING DIAGRAM

E289277
1.167,0.635 1.583,0.833 0.417,0.198 10 false SLD1 1.188,1.417 1.542,1.604 0.354,0.188 10 false II1+ 1.198,2.219 1.552,2.406 0.354,0.188 10 false II1- 5.625,1.438 5.979,1.625 0.354,0.188 10 false RL+ 5.615,2.24 5.969,2.427 0.354,0.188 10 false RL- 1.625,0.531 1.979,0.719 0.354,0.188 10 false 18 1.635,1.313 1.99,1.5 0.354,0.188 10 false 15 1.625,2.104 1.979,2.292 0.354,0.188 10 false 14 0.552,2.698 1.115,2.896 0.563,0.198 10 false M22 0.583,2.854 2.302,3.198 1.719,0.344 10 false Stereo Component Amplifier Assembly 3.313,2.594 3.865,2.771 0.552,0.177 10 false Shielded 5.333,1.313 5.688,1.5 0.354,0.188 10 false 2 5.323,2.115 5.677,2.302 0.354,0.188 10 false 6 5.469,2.667 5.823,2.854 0.354,0.188 10 false G142 5.458,2.823 6.667,3.177 1.208,0.354 10 false Navigation Receiver Assembly

CAUTION / NOTICE / HINT

NOTICE:

Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY- STEREO COMPONENT AMPLIFIER ASSEMBLY)
a.

Disconnect the G142 navigation receiver assembly connector.


b.

Disconnect the M22 stereo component amplifier connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
M22-15 (II1+) - G142-2 (RL+) Always Below 1 Ω
M22-14 (II1-) - G142-6 (RL-) Always Below 1 Ω
M22-15 (II1+) - Body ground Always 10 kΩ or higher
M22-14 (II1-) - Body ground Always 10 kΩ or higher
M22-18 (SLD) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR