Home › Engine / Hybrid System › 1AD-FTV EMISSION CONTROL › EXHAUST GAS TEMPERATURE SENSOR › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008371 1AD-FTV EMISSION CONTROL _0046704 EXHAUST GAS TEMPERATURE SENSOR A

1AD-FTV EMISSION CONTROL  EXHAUST GAS TEMPERATURE SENSOR  REMOVAL  


PROCEDURE

Hide 89425 2.REMOVE EXHAUST GAS TEMPERATURE SENSOR

NOTICE:

If the exhaust gas temperature sensor is dropped, replace it with a new one.


a.
A263931

Disconnect the exhaust gas temperature sensor connector and detach the exhaust gas temperature sensor connector clamp.


b.

Using a 14 mm union nut wrench, remove the exhaust gas temperature sensor.


Hide 25589 4.REMOVE NO. 4 MANIFOLD CONVERTER INSULATOR

Hide 17119 7.REMOVE NO. 2 EXHAUST MANIFOLD STAY

Hide 25051 8.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

Hide 89425A 9.REMOVE NO. 2 EXHAUST GAS TEMPERATURE SENSOR

NOTICE:

If the No. 2 exhaust gas temperature sensor is dropped, replace it with a new one.


a.
A263932

Detach the No. 2 exhaust gas temperature sensor connector clamp.


b.

Using a 14 mm union nut wrench, loosen the union nut.


c.

Remove the nut, clamp and No. 2 exhaust gas temperature sensor.


Hide 89425B 10.REMOVE NO. 3 EXHAUST GAS TEMPERATURE SENSOR

NOTICE:

If the No. 3 exhaust gas temperature sensor is dropped, replace it with a new one.


a.
A263933

Detach the No. 3 exhaust gas temperature sensor connector clamp.


b.

Using a 14 mm union nut wrench, remove the No. 3 exhaust gas temperature sensor.