Home › Engine / Hybrid System › 1AD-FTV EMISSION CONTROL › MONOLITHIC CONVERTER › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008371 1AD-FTV EMISSION CONTROL _0046708 MONOLITHIC CONVERTER A

1AD-FTV EMISSION CONTROL  MONOLITHIC CONVERTER  REMOVAL  


PROCEDURE

Hide 25589 2.REMOVE NO. 4 MANIFOLD CONVERTER INSULATOR

a.
A263919

Remove the 4 bolts and No. 4 manifold converter insulator.


Hide 25509 3.REMOVE MANIFOLD CONVERTER INSULATOR SUB-ASSEMBLY

a.
A263991

Remove the bolt and manifold converter insulator sub-assembly.


Hide 17118 4.REMOVE MANIFOLD STAY

a.
A197483

Remove the bolt, nut and manifold stay.


Hide 17139 5.REMOVE NO. 2 MANIFOLD STAY

a.
A197481

Remove the 3 bolts and No. 2 manifold stay.


Hide 17119 6.REMOVE NO. 2 EXHAUST MANIFOLD STAY

a.
A197482

Remove the 2 bolts, nut and No. 2 exhaust manifold stay.


Hide 25051 7.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

a.

Disconnect the No. 2 exhaust gas temperature sensor connector and No. 3 exhaust gas temperature sensor connector.


b.
A263920

Remove the 3 nuts and exhaust manifold converter sub-assembly.


c.

Remove the gasket from the turbocharger sub-assembly.


Hide 25760A 8.REMOVE VACUUM TRANSMITTING HOSE ASSEMBLY

a.

Slide the clamp and disconnect the vacuum transmitting hose assembly from the No. 1 vacuum pipe.


Hide 25770A 9.REMOVE NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY

a.

Slide the clamp and disconnect the No. 2 vacuum transmitting hose assembly from the No. 2 vacuum pipe.


Hide 89425 10.REMOVE EXHAUST GAS TEMPERATURE SENSOR

Hide 89425A 11.REMOVE NO. 2 EXHAUST GAS TEMPERATURE SENSOR

Hide 89425B 12.REMOVE NO. 3 EXHAUST GAS TEMPERATURE SENSOR

Hide 25733A 13.REMOVE NO. 1 VACUUM PIPE

a.
A263923

Using a 17 mm union nut wrench, loosen the union nut.


b.

Remove the bolt and No. 1 vacuum pipe.


Hide 25734 14.REMOVE NO. 2 VACUUM PIPE

a.
A263924

Using a 14 mm union nut wrench, loosen the union nut.


b.

Remove the bolt and No. 2 vacuum pipe.


Hide 25587 15.REMOVE NO. 2 MANIFOLD CONVERTER INSULATOR

a.
A263925

Remove the 3 bolts and No. 2 manifold converter insulator.