Home › Engine / Hybrid System › 2AD-FTV ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL
RM3090E _51 Engine / Hybrid System _008372 2AD-FTV ENGINE MECHANICAL _0046717 FRONT CRANKSHAFT OIL SEAL A

2AD-FTV ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 16361A 1.REMOVE FAN AND GENERATOR V BELT

Hide 13471 2.REMOVE CRANKSHAFT PULLEY

a.
A273394
1.417,1.958 0.844,0.833 0.844,0.833 0.646,0.833 true 2.438,0.667 1.698,0.667 true 2.26,2.427 2.552,2.094 2.552,2.094 2.729,2.094 false 0.323,0.75 0.781,0.948 0.458,0.198 10 false SST 1.365,0.563 1.823,0.76 0.458,0.198 10 false SST 2.792,2.01 3.25,2.208 0.458,0.198 10 false SST

Using SST, hold the crankshaft pulley and loosen the pulley bolt until 2 or 3 threads are screwed into the crankshaft.

SST
09213-58014  (91551-80840)
09330-00021  


b.
A273395
1.927,0.865 1.427,0.865 true 1.104,0.771 1.563,0.969 0.458,0.198 10 false SST

Using SST and the pulley bolt, remove the crankshaft pulley and pulley bolt.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05020, 09954-05021)


Hide 11301C 3.REMOVE FRONT CRANKSHAFT OIL SEAL

a.
A291622
1.677,1.125 2.177,0.688 2.177,0.688 2.396,0.688 true 2.438,0.594 2.75,0.792 0.313,0.198 10 false *1
*1 Protective Tape


Using a screwdriver, pry out the front crankshaft oil seal.

NOTICE:
·

Do not damage the surface of the front crankshaft oil seal press fit hole or the crankshaft.

·

After removing the front crankshaft oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.



HINT:

Tape the screwdriver tip before use.