Home › Engine / Hybrid System › 2AD-FTV ENGINE CONTROL › ECM
RM3090E _51 Engine / Hybrid System _008377 2AD-FTV ENGINE CONTROL _0046796 ECM A

2AD-FTV ENGINE CONTROL  ECM  REMOVAL  


PROCEDURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 17705 5.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 17801 6.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 89661 8.REMOVE ECM

a.

Disconnect the 2 ECM connectors.

i.
A124571C02
0.542,0.719 1.573,0.219 1.573,0.219 1.729,0.219 true 1.792,0.156 2.104,0.313 0.313,0.156 10 *1 0.219,0.302 0.531,0.458 0.313,0.156 10 *a
*1 Lock
*a Push


Raise the 2 levers while pushing the locks on the levers and disconnect the 2 ECM connectors.

NOTICE:

After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.




b.
A273326

Remove the 3 bolts and ECM with bracket.


c.
A273327

Remove the 4 screws, No. 1 ECM bracket and No. 2 ECM bracket.