Home › Engine / Hybrid System › 3ZR-FAE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL › 2012.12–2015.04
RM3090E _51 Engine / Hybrid System _008387 3ZR-FAE ENGINE MECHANICAL _0046809 FRONT CRANKSHAFT OIL SEAL A

3ZR-FAE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 11212 1.REMOVE NO. 2 CYLINDER HEAD COVER

Hide 51441 2.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51443 3.REMOVE REAR ENGINE UNDER COVER RH

Hide 51217A 4.REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

Hide 13471 6.REMOVE CRANKSHAFT PULLEY

a.
A293587C01
1.24,1.74 2.625,0.885 2.625,0.885 2.781,0.885 true 1.719,2.031 2.625,0.885 true 0.479,2.865 0.792,3.021 0.313,0.156 10 *a 2.823,0.823 3.281,1.021 0.458,0.198 10 SST
*a Hold
V100135

Turn


Using SST, hold the crankshaft pulley and loosen the pulley bolt until 2 or 3 threads are screwed into the crankshaft.

for 86 mm (3.39 in.) Bolt Pitch Type:

SST
09213-58014  (91551-80840)
09330-00021  

for 64 mm (2.52 in.) Bolt Pitch Type:

SST
09213-54015  09330-00021  

HINT:

For the 64 mm (2.52 in.) bolt pitch type, the part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).



b.
A234912C05
1.604,2.458 2.573,0.792 2.573,0.792 2.75,0.792 true 0.094,1.76 0.292,1.927 0.198,0.167 10 *a 2.781,0.708 3.104,0.896 0.323,0.188 10 SST
*a Hold
V100135

Turn


Using SST and the pulley bolt, remove the crankshaft pulley and pulley bolt.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05020, 09954-05021)

HINT:

Apply lubricant to the threads and end of SST.



Hide 11302A 7.REMOVE TIMING CHAIN COVER OIL SEAL

a.
A200713C01
1.833,0.688 2.031,1 2.031,1 2.146,1 true 2.167,0.917 2.333,1.094 0.167,0.177 10 *1
*1 Protective Tape


Using a screwdriver, pry out the timing chain cover oil seal.

NOTICE:
·

Do not damage the surface of the timing chain cover oil seal press fit hole or the crankshaft.

·

After removing the timing chain cover oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.



HINT:

Tape the screwdriver tip before use.