Home › Engine / Hybrid System › 3ZR-FAE INTAKE / EXHAUST › EXHAUST MANIFOLD › 2012.12–2015.04
RM3090E _51 Engine / Hybrid System _008390 3ZR-FAE INTAKE / EXHAUST _0046829 EXHAUST MANIFOLD A

3ZR-FAE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


PROCEDURE

Hide 11212 1.REMOVE NO. 2 CYLINDER HEAD COVER

Hide 89467B 2.REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

Hide 3.REMOVE WIRE HARNESS CLAMP BRACKET

a.
A207697

Detach the clamp and disconnect the fuel hose.


b.

Remove the bolt and wire harness clamp bracket.


Hide 17167 4.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

a.
A207698

Remove the 3 bolts and No. 1 exhaust manifold heat insulator.


Hide 17410 5.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.
A207699

Remove the 2 bolts and disconnect the front exhaust pipe assembly from the center exhaust pipe assembly.


b.
A207700

Remove the 2 bolts, 2 compression springs and front exhaust pipe assembly.


c.

Remove the gasket from the front exhaust pipe assembly.


d.

Remove the gasket from the exhaust manifold.


Hide 17118 6.REMOVE MANIFOLD STAY

a.
A207701

Remove the 3 bolts and manifold stay.


Hide 17141 7.REMOVE EXHAUST MANIFOLD

a.
A207702

Remove the 5 nuts and exhaust manifold.


b.

Remove the exhaust manifold gasket from the cylinder head.


Hide 17168 8.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

a.
A207703

Remove the 3 bolts and No. 2 exhaust manifold heat insulator.