Do not try to remove the black nylon tube as it is welded to the fuel suction tube assembly.
Click hereEngine / Hybrid System>2AR-FE FUEL>FUEL SYSTEM(w/o Canister Pump Module)>PRECAUTION
Perform "Inspection After Repairs" after replacing the fuel pump.
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/o Canister Pump Module)>INITIALIZATION
23221
1.INSTALL FUEL PUMP
Perform "Inspection After Repairs" after replacing the fuel pump.
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/o Canister Pump Module)>INITIALIZATION
| *1 | Fuel Pump Spacer |
| *2 | New O-Ring |
Apply gasoline to a new O-ring. Then install the O-ring and fuel pump spacer to the fuel pump.
Connect the fuel pump connector.
Attach the 5 claws to the holes to install the fuel pump.
77174
2.INSTALL NO. 1 FUEL SUCTION SUPPORT
Attach the 2 claws to the holes to install the No. 1 fuel suction support.
77131C
3.INSTALL NO. 1 FUEL SUB-TANK
Apply gasoline to a new O-ring and install it to the jet pump.
Install the jet pump while aligning it with the installation position on the No. 1 fuel sub-tank.
Install the jet pump nozzle.
Attach the 2 claws to the holes to install the No. 1 fuel sub-tank.
Connect the wire harness connector.
Install the 2 springs to the fuel suction plate, and then install them to No. 1 fuel sub-tank.
Install a new E-ring.
Slightly lower the fuel suction plate to install the E-ring.