Home › Engine / Hybrid System › 2AR-FE INTAKE / EXHAUST › EXHAUST MANIFOLD
RM3090E _51 Engine / Hybrid System _008399 2AR-FE INTAKE / EXHAUST _0046897 EXHAUST MANIFOLD A

2AR-FE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


PROCEDURE

Hide 17401 2.REMOVE FRONT EXHAUST PIPE SUB-ASSEMBLY

a.
A197097

Disconnect the heated oxygen sensor connector.


b.

Remove the 4 bolts, 2 compression springs and front exhaust pipe sub-assembly.

A293426


c.

Remove the gasket from the front exhaust pipe sub-assembly.


d.

Remove the gasket from the exhaust manifold converter sub-assembly.


Hide 11452 3.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE

Hide 16581B 4.REMOVE RADIATOR HOSE HOSE CLAMP

Hide 89467B 5.REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

Hide 17118 6.REMOVE MANIFOLD STAY

a.
A195975

Remove the bolt, nut and manifold stay.


Hide 17139 7.REMOVE NO. 2 MANIFOLD STAY

a.
A195976

Remove the bolt, nut and No. 2 manifold stay.


Hide 17167 8.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

a.
A195977

Remove the 4 bolts and No. 1 exhaust manifold heat insulator.


Hide 17168 9.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

a.
A195978

Remove the 2 bolts and No. 2 exhaust manifold heat insulator.


Hide 25051 10.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

a.
A293724
3.104,1.667 3.188,1.844 0.083,0.177 10 1 0.281,1.656 0.375,1.854 0.094,0.198 10 2 2.677,0.021 2.792,0.198 0.115,0.177 10 3 0.677,0.01 0.771,0.177 0.094,0.167 10 4 1.438,1.677 1.563,1.833 0.125,0.156 10 5

Remove the 5 nuts in the sequence shown in the illustration, and then remove the exhaust manifold converter sub-assembly and gasket.


Hide 25586 11.REMOVE NO. 1 MANIFOLD CONVERTER INSULATOR

a.
A195980

Remove the 4 bolts and No. 1 manifold converter insulator.