Home › Engine / Hybrid System › 2AR-FE INTAKE / EXHAUST › EXHAUST PIPE
RM3090E _51 Engine / Hybrid System _008399 2AR-FE INTAKE / EXHAUST _0046898 EXHAUST PIPE A

2AR-FE INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Wear protective gloves when removing the exhaust pipe.

·

The exhaust pipe is extremely hot immediately after the engine has stopped.

·

Confirm that the exhaust pipe has cooled down before removing it.



PROCEDURE

Hide 17430 1.REMOVE TAIL EXHAUST PIPE ASSEMBLY

a.

Remove the 2 bolts and 2 compression springs.


b.

Disconnect the 2 exhaust pipe supports and remove the tail exhaust pipe assembly.


c.

Remove the gasket from the center exhaust pipe assembly.

A293428


Hide 17420 2.REMOVE CENTER EXHAUST PIPE ASSEMBLY

a.

Remove the 2 bolts.


b.

Disconnect the 3 exhaust pipe supports and remove the center exhaust pipe assembly.

A293429


c.

Remove the gasket from the front No. 2 exhaust pipe sub-assembly.


Hide 17402 3.REMOVE FRONT NO. 2 EXHAUST PIPE SUB-ASSEMBLY

a.
A293398

Disconnect the heated oxygen sensor connector.


b.
A293431

Remove the 2 bolts and front No. 2 exhaust pipe sub-assembly.


c.

Remove the gasket from the front exhaust pipe sub-assembly.


Hide 17401 4.REMOVE FRONT EXHAUST PIPE SUB-ASSEMBLY

a.
A293430

Remove the 2 bolts, 2 compression springs and front exhaust pipe sub-assembly.


b.

Remove the gasket from the exhaust manifold converter sub-assembly.


Hide 89465 5.REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)