Do not remove the oil pump or oil pump relief valve from the timing chain cover sub-assembly.
1.REMOVE ENGINE AND TRANSAXLE
2.DISCONNECT ENGINE WIRE
Disconnect the connectors and clamps securing the engine wire from the engine.
19500
3.REMOVE IGNITION COIL ASSEMBLY
11201
4.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY
Remove the 16 bolts, 3 seal washers, cylinder head cover sub-assembly and cylinder head cover gasket.
Remove the 2 camshaft bearing cap oil hole gaskets from the No. 1 camshaft bearing cap.
Remove the gasket from the No. 2 camshaft bearing cap.
11193
5.REMOVE SPARK PLUG TUBE GASKET
Using a screwdriver, pry out the 4 spark plug tube gaskets.
Be careful not to damage the cylinder head cover sub-assembly.
Tape the screwdriver tip before use.
11301K
6.REMOVE CRANKSHAFT POSITION SENSOR
13471
7.REMOVE CRANKSHAFT PULLEY
12315A
8.REMOVE ENGINE MOUNTING BRACKET RH
Remove the 4 bolts and engine mounting bracket RH.
16620
9.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
11310
10.REMOVE TIMING CHAIN COVER ASSEMBLY
Remove the 17 bolts and 2 nuts.
| *1 | Protective Tape |
Remove the timing chain cover sub-assembly by prying between the timing chain cover sub-assembly and cylinder head, camshaft housing, cylinder block and stiffening crankcase with a screwdriver as shown in the illustration.
Be careful not to damage the contact surfaces of the cylinder head, camshaft housing, cylinder block, stiffening crankcase and timing chain cover sub-assembly.
Tape the screwdriver tip before use.
Remove the 2 oil pump gaskets from the stiffening crankcase.
Remove the oil hole cover gasket from the stiffening crankcase.
11301C
11.REMOVE TIMING CHAIN COVER OIL SEAL
| *1 | Protective Tape |
| *2 | Wooden Block |
Using a screwdriver and wooden block, pry out the oil seal.
Do not damage the surface of the oil seal press fit hole.
Tape the screwdriver tip before use.