1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL
74404A
4.REMOVE BATTERY CLAMP SUB-ASSEMBLY
Remove the bolt and loosen the nut.
Detach the 2 wire harness clamps.
Detach the hook of the battery clamp sub-assembly from the front battery bracket, and then remove the battery clamp sub-assembly.
28899
5.REMOVE BATTERY INSULATOR
28800
6.REMOVE BATTERY
74431
7.REMOVE BATTERY TRAY
74411B
8.REMOVE FRONT BATTERY BRACKET
Remove the 4 bolts and front battery bracket.
74414B
9.REMOVE BATTERY BRACKET REINFORCEMENT
Remove the 2 bolts and battery bracket reinforcement.
28100
10.REMOVE STARTER ASSEMBLY
Disconnect the starter connector and remove the terminal cap.
Remove the nut and disconnect the starter wire.
Remove the 2 bolts and starter assembly.