89668
1.INSTALL NO. 2 ECM BRACKET
Install the No. 2 ECM bracket with the 2 screws.
89667E
2.INSTALL NO. 1 ECM BRACKET
Install the No. 1 ECM bracket with the 2 screws.
89661
3.INSTALL ECM
Install the ECM with the 3 bolts.
Connect the 2 ECM connectors and lower the 2 levers.
When connecting a connector, make sure that dirt, water and other foreign matter is not stuck between the connector and ECM.
Make sure that the 2 levers are securely lowered.
4.INSTALL AIR CLEANER CASE
Install the air cleaner case with the 2 bolts.
Attach the harness clamp.
17705
5.INSTALL AIR CLEANER CAP SUB-ASSEMBLY
Install the air cleaner filter element to the air cleaner case.
| *a | RH Side |
| *b | Rear |
Align the protrusion on the end of the air cleaner cap sub-assembly with the edge of the throttle with motor body assembly and connect the hose. Then, release the lock of the air cleaner cap sub-assembly clamp to secure the clamp.
| *1 | Hinge |
Insert the hinge part of the air cleaner cap sub-assembly into the air cleaner case, and then attach the 2 hook clamps.
Connect the No. 2 PCV hose to the cylinder head cover.
Connect the fuel vapor feed hose and No. 2 fuel vapor feed hose to the purge VSV, and slide the 2 clamps to secure it.
Attach the 2 wire harness clamps.
Connect the purge VSV connector.
Connect the mass air flow meter sub-assembly connector.
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
7.PERFORM REGISTRATION
w/ Canister Pump Module:
When replacing the ECM, input the Vehicle Identification Number (VIN) into the new ECM.
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/ Canister Pump Module)>REGISTRATION
w/o Canister Pump Module
When replacing the ECM, input the Vehicle Identification Number (VIN) into the new ECM.
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/o Canister Pump Module)>REGISTRATION
8.RESET MEMORY (for Automatic Transaxle)
When replacing the ECM, perform the Reset Memory procedure (A/T initialization).
Click hereDrivetrain>U760F AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>PRECAUTION