Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › ECM
RM3090E _51 Engine / Hybrid System _008378 2AR-FE ENGINE CONTROL _0046922 ECM A

2AR-FE ENGINE CONTROL  ECM  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time maybe required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 17705 3.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

a.
A293386

Disconnect the mass air flow meter sub-assembly connector.


b.

Disconnect the purge VSV connector.


c.

Detach the 2 wire harness clamps.


d.

Slide the 2 clamps and disconnect the fuel vapor feed hose and No. 2 fuel vapor feed hose from the purge VSV.


e.

Disconnect the No. 2 PCV hose from the cylinder head cover.


f.
A293387

Lock the air cleaner cap sub-assembly hose clamp, and then disconnect the air cleaner cap sub-assembly from the throttle with motor body assembly.


g.
A293388

Detach the 2 hook clamps, and then remove the air cleaner cap sub-assembly.


h.

Remove the air cleaner filter element from the air cleaner case.


Hide 4.REMOVE AIR CLEANER CASE

a.
A293389

Detach the harness clamp.


b.

Remove the 2 bolts and air cleaner case.


Hide 89661 5.REMOVE ECM

a.
A293343C01
0.313,1.177 0.313,1.021 0.313,1.021 0.594,0.813 true 0.313,2.802 0.313,2.635 0.313,2.635 0.677,2.448 true 0.688,0.177 0.927,0.385 0.24,0.208 10 *a 0.24,1.198 0.552,1.354 0.313,0.156 10 *b 0.75,1.833 0.99,2.042 0.24,0.208 10 *a 0.24,2.823 0.552,2.979 0.313,0.156 10 *b
*a Push
*b Lock


Disconnect the 2 ECM connectors.

NOTICE:

After disconnecting a connector, make sure that dirt, water and other foreign matter does not contact the connector.


i.

Raise the 2 levers while pushing the locks on the 2 levers and disconnect the 2 ECM connectors.



b.
A293344

Remove the 3 bolts and ECM.


Hide 89667E 6.REMOVE NO. 1 ECM BRACKET

a.
A293346

Remove the 2 screws and No. 1 ECM bracket.


Hide 89668 7.REMOVE NO. 2 ECM BRACKET

a.
A293345

Remove the 2 screws and No. 2 ECM bracket.