Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.
w/ Canister Pump Module
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/ Canister Pump Module)>INITIALIZATION
w/o Canister Pump Module
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/o Canister Pump Module)>INITIALIZATION
89467B
1.INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
| *1 | Fulcrum Length |
Using SST, install the air fuel ratio sensor to the exhaust manifold.
Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Make sure SST and the wrench are connected in a straight line.
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.
w/ Canister Pump Module
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/ Canister Pump Module)>INITIALIZATION
w/o Canister Pump Module
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/o Canister Pump Module)>INITIALIZATION
Connect the air fuel ratio sensor connector.
16581B
2.INSTALL RADIATOR HOSE HOSE CLAMP
3.INSPECT FOR EXHAUST GAS LEAK