Home › Engine / Hybrid System › 2AD-FHV ENGINE MECHANICAL › CYLINDER HEAD GASKET
RM3090E _51 Engine / Hybrid System _008404 2AD-FHV ENGINE MECHANICAL _0046935 CYLINDER HEAD GASKET A

2AD-FHV ENGINE MECHANICAL  CYLINDER HEAD GASKET  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 17141 3.REMOVE EXHAUST MANIFOLD WITH TURBOCHARGER SUB-ASSEMBLY

Hide 23710B 5.REMOVE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

Hide 19850 7.REMOVE GLOW PLUG ASSEMBLY

Hide 11101 8.REMOVE CYLINDER HEAD SUB-ASSEMBLY

a.
A273375N02
2.75,0.26 2.906,0.458 0.156,0.198 10 1 1.531,0.25 1.823,0.448 0.292,0.198 10 10 2.167,0.26 2.323,0.458 0.156,0.198 10 5 0.979,0.24 1.135,0.438 0.156,0.198 10 8 0.396,0.26 0.552,0.458 0.156,0.198 10 4 0.375,1.781 0.531,1.979 0.156,0.198 10 2 0.99,1.802 1.146,2 0.156,0.198 10 6 1.563,1.802 1.719,2 0.156,0.198 10 9 2.177,1.792 2.333,1.99 0.156,0.198 10 7 2.76,1.792 2.917,1.99 0.156,0.198 10 3

Uniformly loosen the 10 bolts in several steps in the sequence shown in the illustration. Remove the 10 cylinder head set bolts and plate washers.

NOTICE:

Head warpage or cracking could result from removing bolts in the incorrect order.



Hide 11115 9.REMOVE CYLINDER HEAD GASKET