11212
1.REMOVE NO. 2 CYLINDER HEAD COVER
51441
2.REMOVE NO. 1 ENGINE UNDER COVER
51443
3.REMOVE REAR ENGINE UNDER COVER RH
51217A
4.REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH
16361A
5.REMOVE V-RIBBED BELT
13471
6.REMOVE CRANKSHAFT PULLEY
| *a | Hold |
|
Turn |
Using SST, hold the crankshaft pulley and loosen the pulley bolt. Further loosen pulley the bolt until 2 or 3 threads are screwed into the crankshaft.
for 86 mm (3.39 in.) Bolt Pitch Type:
for 64 mm (2.52 in.) Bolt Pitch Type:
For the 64 mm (2.52 in.) bolt pitch type, the part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).
| *a | Hold |
|
Turn |
Using SST and the pulley bolt, remove the crankshaft pulley and pulley bolt.
Apply lubricant to the threads and end of SST.
11302A
7.REMOVE TIMING CHAIN COVER OIL SEAL
| *1 | Protective Tape |
Using a screwdriver, pry out the oil seal.
Do not damage the surface of the oil seal press fit hole or the crankshaft.
After removing the oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.
Tape the screwdriver tip before use.