Home › Engine / Hybrid System › 3ZR-FE ENGINE CONTROL › HEATED OXYGEN SENSOR
RM3090E _51 Engine / Hybrid System _008380 3ZR-FE ENGINE CONTROL _0047000 HEATED OXYGEN SENSOR A

3ZR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSTALLATION  


PROCEDURE

Hide 89465 1.INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

a.
A293363C01
1.615,0.885 1.688,0.229 1.688,0.229 1.833,0.229 true 0.51,1.729 0.823,1.885 0.313,0.156 10 *1 1.885,0.146 2.344,0.344 0.458,0.198 10 SST
*1 Fulcrum Length


Using SST, install the heated oxygen sensor to the center exhaust pipe assembly.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

Make sure SST and the wrench are connected in a straight line.



NOTICE:

Do not damage the heated oxygen sensor.



b.

Pass the heated oxygen sensor connector through the floor panel and install the grommet.


c.

Connect the heated oxygen sensor connector.


Hide 58901A 2.INSTALL REAR CONSOLE BOX SUB-ASSEMBLY