Home › Drivetrain › K111 MULTIDRIVE / CVT › PARK / NEUTRAL POSITION SWITCH
RM3090E _52 Drivetrain _008435 K111 MULTIDRIVE / CVT _0047076 PARK / NEUTRAL POSITION SWITCH A

K111 MULTIDRIVE / CVT  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Install the park/neutral position switch to the continuously variable transaxle aasembly.


b.
C169001

Temporarily install the 2 bolts.


c.
C169002

Install a new lock plate and the lock nut to the park/neutral position switch assembly.

Torque:
6.9 N*m (70 kgf*cm, 61 in.*lbf)


d.

Temporarily install the control shaft lever.


e.
C169003E02
3.107,0.257 3.236,0.429 0.129,0.172 10 N 3.283,0.6 3.413,0.772 0.129,0.172 10 R 3.256,1.274 3.386,1.446 0.129,0.172 10 P

Turn the lever clockwise until it stops, and then turn it counterclockwise 2 notches.


f.

Remove the control shaft lever.


g.
C169004C02
2.667,0.74 2.542,0.74 2.542,0.74 1.563,0.875 false 2.667,1.271 2.552,1.271 2.552,1.271 1.51,1.052 false 2.708,0.656 2.938,0.865 0.229,0.208 10 false *a 2.688,1.177 2.896,1.323 0.208,0.146 10 false *b
*a Neutral Basic Line
*b Protrusion


Align the protrusion with the neutral basic line.


h.

Hold the switch in that position and tighten the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


i.
C169005

Using a screwdriver, bend the tabs of the lock plate.


j.
C168295

Install the control shaft lever with the washer and nut.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


k.

Connect the park/neutral position switch connector.


Hide 33820B 2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Connect the transmission control cable assembly to the control shaft lever with the nut.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 84540 5.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

Hide 51441 6.INSTALL NO. 1 ENGINE UNDER COVER