1.INSTALL TCM
Install the TCM to the transaxle.
Install and tighten the 2 bolts in the order shown in the illustration.
Connect the connector to the TCM.
Turn the lock lever until the claw of the connector makes a connection sound and secure the connector with the lock lever.
74414B
2.INSTALL BATTERY BRACKET REINFORCEMENT
74411B
3.INSTALL BATTERY BRACKET FRONT
74431
4.INSTALL BATTERY TRAY
5.INSTALL BATTERY
28899
6.INSTALL BATTERY INSULATOR
74404A
7.INSTALL BATTERY CLAMP SUB-ASSEMBLY
8.CONNECT CABLE TO POSITIVE BATTERY TERMINAL
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).