Home › Engine / Hybrid System › 2AR-FE LUBRICATION › ENGINE OIL COOLER(w/ Oil Cooler)
RM3090E _51 Engine / Hybrid System _008401 2AR-FE LUBRICATION _0047980 ENGINE OIL COOLER(w/ Oil Cooler) A

2AR-FE LUBRICATION  ENGINE OIL COOLER(w/ Oil Cooler)  INSTALLATION  


PROCEDURE

Hide 15710 1.INSTALL OIL COOLER ASSEMBLY

a.

Clean the oil cooler assembly contact surface on the cooler mounting.


b.

Apply a light coat of engine oil to 3 new gaskets.


c.

Install the 3 new gaskets to the oil cooler assembly.


d.

Temporarily install the oil cooler assembly with the union bolt, the nut and a new seal washer.


e.
A296893
1.479,1 1.958,0.573 1.958,0.573 2.094,0.573 true 1.615,1.104 2.021,0.823 2.021,0.823 2.156,0.823 true 0.24,1.688 0.24,1.552 0.24,1.552 0.802,1.135 true 2.135,0.469 2.323,0.646 0.188,0.177 10 *1 2.188,0.729 2.375,0.906 0.188,0.177 10 *2 0.167,1.719 0.354,1.896 0.188,0.177 10 *3 0.76,0.479 0.896,0.646 0.135,0.167 10 2 2.021,1.26 2.156,1.427 0.135,0.167 10 1
*1 Seal Washer
*2 Union Bolt
*3 Nut


Tighten the bolt and nut in several steps in the sequence shown in the illustration.

Torque:
for union bolt : 60 N*m (612 kgf*cm, 44 ft.*lbf)
for nut : 10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 25051 2.INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY