Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › 2012.12–2015.10
RM3090E _56 Audio / Visual / Telematics _008432 PARK ASSIST / MONITORING _0047058 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1AB8  Destination Information Undefined  


DESCRIPTION

This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot monitor has been replaced.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AB8 Destination Information Undefined The blind spot monitor sensor cannot communicate with the main body ECU (multiplex network body ECU).
·

CAN communication system (for LHD)

·

CAN communication system (for RHD)

·

Main body ECU (multiplex network body ECU)

·

Blind spot monitor sensor LH

·

Blind spot monitor sensor RH



CAUTION / NOTICE / HINT

NOTICE:
·

When checking for DTCs, make sure that the blind spot monitor main switch (warning cancel switch assembly*1 or telltale light assembly*2) is on.

*1: for LHD

*2: for RHD


·

When replacing the main body ECU (multiplex network body ECU), make sure to replace it with a new one.



PROCEDURE

1.CHECK DTC


Result:
Proceed to
CAN communication system DTCs are not output
CAN communication system DTCs are output (for LHD)
CAN communication system DTCs are output (for RHD)



CAN communication system DTCs are not output

2.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

CAN communication system DTCs are output (for LHD)

CAN communication system DTCs are output (for RHD)

2.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
a.

for LHD

i.

Replace the main body ECU (multiplex network body ECU).

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for LHD)>REMOVAL



b.

for RHD

i.

Replace the main body ECU (multiplex network body ECU).

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for RHD)>REMOVAL



Result:
Proceed to
NEXT



NEXT

3.RECHECK DTC
3.RECHECK DTC
a.

Recheck for DTCs and check if the same DTC is output again.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Blind Spot Monitor Master > Trouble Codes
50001 313
Body Electrical > Blind Spot Monitor Slave > Trouble Codes
50001 314
Result:
Proceed to
No DTC is output
DTC is output from the blind spot monitor sensor LH (Master)
DTC is output from the blind spot monitor sensor RH (Slave)




No DTC is output

END (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) IS DEFECTIVE)

DTC is output from the blind spot monitor sensor LH (Master)

DTC is output from the blind spot monitor sensor RH (Slave)