This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U1331 | Software Incompatibility with Body Control Module "B" | Destination information of the main body ECU (multiplex network body ECU) and blind spot monitor sensor do not match. | ·
Main body ECU (multiplex network body ECU) ·
Blind spot monitor sensor LH ·
Blind spot monitor sensor RH |
When checking for DTCs, make sure that the blind spot monitor main switch (warning cancel switch assembly*1 or telltale light assembly*2) is on.
*1: for LHD
*2: for RHD
When replacing the main body ECU (multiplex network body ECU), make sure to replace it with a new one.
Check the main body ECU (multiplex network body ECU) part number.
Check if the part number of the main body ECU (multiplex network body ECU) installed on the vehicle is correct.
The part number is correct.
| Proceed to |
|---|
| OK |
| NG (for LHD) |
| NG (for RHD) |
OK
NG (for LHD)
NG (for RHD)
Clear the DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check if the same DTC is output again.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| No DTC is output |
| DTC is output from the blind spot monitor sensor LH (Master) |
| DTC is output from the blind spot monitor sensor RH (Slave) |
No DTC is output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTC is output from the blind spot monitor sensor LH (Master)
DTC is output from the blind spot monitor sensor RH (Slave)