41221
1.REMOVE FRONT DIFFERENTIAL RING GEAR
| *a | Matchmark |
Place matchmarks on the front differential ring gear and front differential case.
Remove the 12 bolts.
Using a plastic-faced hammer, remove the front differential ring gear from the front differential case.
2.INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH
41342A
3.REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN
Using SST and a hammer, loosen the staked part of the front differential case.
Do not grind the tup of SST with a grinder other device.
Using a 5 mm pin punch and hammer, tap out the front differential pinion shaft straight pin from the front differential case.
41342F
4.REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT
Remove the front No. 1 differential pinion shaft from the front differential case.
41331F
5.REMOVE FRONT DIFFERENTIAL SIDE GEAR
Remove the 2 front differential pinions, 2 front differential pinion thrust washers, 2 front No. 1 differential side gear thrust washers and 2 front differential side gears from the front differential case.
While rotating the 2 front differential side gears, remove the 2 front differential pinions and 2 front differential pinion thrust washers.