23255B
1.INSTALL FUEL INJECTOR SEAL
Install a new fuel injector seal to the exhaust fuel addition injector assembly.
23710B
2.INSTALL EXHAUST FUEL ADDITION INJECTOR ASSEMBLY
If there is foreign matter on the installation surface of the exhaust fuel addition injector assembly, be sure to clean the exhaust fuel addition injector assembly before installation.
Install a new gasket, the exhaust fuel addition injector assembly, the nozzle holder clamp, and the washer with the bolt.
| *1 | Nozzle Holder Clamp |
Align the nozzle holder clamp with the cutouts of the exhaust fuel addition injector assembly as shown in the illustration.
23901E
3.INSTALL FUEL TUBE SUB-ASSEMBLY
23292A
4.INSTALL FUEL HOSE PROTECTOR
Install the fuel hose protector with the bolt.
Connect the exhaust fuel addition injector connector.
5.INSTALL AIR CLEANER CASE
17801
6.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
17705
7.INSTALL AIR CLEANER CAP SUB-ASSEMBLY
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
9.BLEED AIR FROM FUEL SYSTEM
10.INSPECT FOR FUEL LEAK
12611
11.INSTALL NO. 1 ENGINE COVER