Home › Engine / Hybrid System › 2AD-FTV EMISSION CONTROL › EXHAUST FUEL ADDITION INJECTOR(for DPF)
RM3090E _51 Engine / Hybrid System _008737 2AD-FTV EMISSION CONTROL _0048712 EXHAUST FUEL ADDITION INJECTOR(for DPF) A

2AD-FTV EMISSION CONTROL  EXHAUST FUEL ADDITION INJECTOR(for DPF)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 17705 4.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 17801 5.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 23292A 7.REMOVE FUEL HOSE PROTECTOR

a.
A206325

Disconnect the exhaust fuel addition injector connector.


b.
A197570

Remove the bolt and fuel hose protector.


Hide 23901E 8.REMOVE FUEL TUBE SUB-ASSEMBLY

Hide 23710B 9.REMOVE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

a.
A201783C02
1.25,0.74 1.417,0.74 1.417,0.74 1.594,0.469 true 2.438,0.667 2.906,0.667 true 1.083,0.646 1.396,0.802 0.313,0.156 10 *1 2.938,0.573 3.25,0.729 0.313,0.156 10 *2
*1 Washer
*2 Nozzle Holder Clamp


Remove the bolt, washer, nozzle holder clamp, exhaust fuel addition injector assembly and gasket.


Hide 23255B 10.REMOVE FUEL INJECTOR SEAL

a.
A201784C02
1.938,0.896 2.521,0.896 true 2.542,0.802 2.854,0.958 0.313,0.156 10 *1
*1 Fuel Injector Seal


Remove the fuel injector seal from the exhaust fuel addition injector assembly.