Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2012.12–2015.10
RM3090E _54 Brake _008767 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0048751 VEHICLE STABILITY CONTROL SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  ABS Warning Light does not Come ON  


DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination assembly meter via CAN communication.

CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform zero point calibration.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
Result:
Proceed to
DTC is not output
DTC is output (for LHD)
DTC is output (for RHD)



DTC is not output

2.CHECK ABS WARNING LIGHT

DTC is output (for LHD)

DTC is output (for RHD)

2.CHECK ABS WARNING LIGHT
a.

Disconnect the A64 skid control ECU (brake actuator assembly) connector.


b.

Turn the ignition switch to ON.


c.

Check that the ABS warning light comes on.

OK:

The ABS warning light comes on.


Result:
Proceed to
OK
NG




OK

NG

3.PERFORM ACTIVE TEST USING GTS (ABS WARNING LIGHT)
3.PERFORM ACTIVE TEST USING GTS (ABS WARNING LIGHT)
a.

Reconnect the A64 skid control ECU (brake actuator assembly) connector.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / ABS/VSC/TRC / Data List.


f.

According to the display on the GTS, perform the Active Test.


Chassis > ABS/VSC/TRC > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
ABS Warning Light ABS warning light Warning light OFF/ON Observe combination meter
Vehicle condition: Vehicle stopped
g.

When performing the ABS Warning Light Active Test, check ABS Warning Light in the Data List.


Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
ABS Warning Light ABS warning light OFF or ON OFF: Warning light off
ON: Warning light on
-
Chassis > ABS/VSC/TRC > Active Test
Active Test Display
ABS Warning Light
Data List Display
ABS Warning Light
50004 105 8 51
Result:
Result Proceed to
ABS warning light in the Data List does not change using the Active Test A
ABS warning light in the Data List turns ON/OFF using the Active Test B



A

B

4.INSPECT COMBINATION METER ASSEMBLY
4.INSPECT COMBINATION METER ASSEMBLY
a.

Turn the ignition switch off.


b.

Perform Active Test of the combination meter assembly using the GTS.


Body Electrical > Combination Meter > Active Test
Tester Display
Indicat. Lamp ABS
50004 122 13
c.

Check the combination meter assembly.


OK:

The ABS warning light turns on or off in accordance with the GTS.


Result:
Proceed to
OK
NG



OK

NG