Home › Engine / Hybrid System › 2AD-FHV ENGINE CONTROL › DIESEL THROTTLE BODY
RM3090E _51 Engine / Hybrid System _008730 2AD-FHV ENGINE CONTROL _0048756 DIESEL THROTTLE BODY A

2AD-FHV ENGINE CONTROL  DIESEL THROTTLE BODY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 51441 4.REMOVE NO. 1 ENGINE UNDER COVER

Hide 17343D 6.REMOVE NO. 3 AIR HOSE

a.
A208799

Loosen the 2 hose clamps.


b.

Remove the No. 3 air hose from the No. 2 air tube and diesel throttle body assembly.


Hide 26100 7.REMOVE DIESEL THROTTLE BODY ASSEMBLY

a.
A203104

Slide the clip and disconnect the No. 7 water by-pass hose from the diesel throttle body assembly.


b.

Slide the clip and disconnect the No. 6 water by-pass hose from the diesel throttle body assembly.


c.

Disconnect the diesel throttle body assembly connector.


d.
A203105

Remove the 2 nuts, 2 bolts, diesel throttle body assembly and gasket.