89661
1.INSTALL ECM
Install the No. 1 ECM bracket and No. 2 ECM bracket to the ECM with the 4 screws.
Install the ECM with bracket with the 3 bolts.
Connect the 2 ECM connectors and lower the 2 levers.
When connecting the ECM connector, make sure that dirt, water or other foreign matter is not stuck between the ECM connector and ECM.
Make sure that the 2 levers are securely lowered.
2.INSTALL AIR CLEANER CASE
17801
3.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
17705
4.INSTALL AIR CLEANER CAP SUB-ASSEMBLY
12611
5.INSTALL NO. 1 ENGINE COVER
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
7.PERFORM REGISTRATION
8.PERFORM INITIALIZATION
9.PERFORM THROTTLE VALVE FULLY CLOSED POSITION LEARNING