Home › Engine / Hybrid System › 2AD-FHV ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM3090E _51 Engine / Hybrid System _008730 2AD-FHV ENGINE CONTROL _0048777 CRANKSHAFT POSITION SENSOR A

2AD-FHV ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11401G 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

NOTICE:
·

When reusing the camshaft position sensor, inspect the O-ring.

·

Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.




b.
A273389
0.854,1.927 0.49,1.385 0.49,1.385 0.333,1.385 true 1.073,0.854 0.604,0.208 0.604,0.208 0.448,0.208 true 0.25,0.135 0.563,0.292 0.313,0.156 10 *1 0.156,1.313 0.469,1.469 0.313,0.156 10 *1
*1 Protrusion


Install the crankshaft position sensor with the bolt.

Torque:
8.8 N*m (90 kgf*cm, 78 in.*lbf)


c.

Install the crankshaft position sensor wire harness with the clip.

NOTICE:

Make sure the crankshaft position sensor wire harness is installed in the position shown in the illustration.



d.

Install the harness clamp bracket with the bolt.

Torque:
8.8 N*m (90 kgf*cm, 78 in.*lbf)


e.

Connect the crankshaft position sensor connector.