27020
1.INSTALL GENERATOR ASSEMBLY
Install the generator assembly with the 3 bolts.
Be careful that the wire harness of the crankshaft position sensor does not get caught between the cylinder block and generator when installing the generator assembly.
Install the wire harness clamp bracket with the bolt.
Install the wire harness to terminal B with the nut.
Install the terminal cap.
Connect the generator connector and attach the wire harness clamp.
2.INSTALL WIRE HARNESS CLAMP BRACKET
Install the wire harness clamp bracket with the bolt.
Attach the wire harness clamp and connect the air fuel ratio sensor connector.
43410
3.INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
16361A
4.INSTALL FAN AND GENERATOR V BELT
12611
5.INSTALL NO. 1 ENGINE COVER
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION