Home › Engine / Hybrid System › 1AD-FTV ENGINE CONTROL › DIESEL THROTTLE BODY › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008729 1AD-FTV ENGINE CONTROL _0048783 DIESEL THROTTLE BODY A

1AD-FTV ENGINE CONTROL  DIESEL THROTTLE BODY  INSTALLATION  


PROCEDURE

Hide 26100 1.INSTALL DIESEL THROTTLE BODY ASSEMBLY

a.

Install a new gasket and the diesel throttle body assembly with the 2 nuts and 2 bolts.

Torque:
11 N*m (112 kgf*cm, 8 ft.*lbf)


b.

Connect the diesel throttle body assembly connector.


c.

Connect the No. 6 water by-pass hose to the diesel throttle body assembly, and slide the clamp to secure the hose.


d.

Connect the No. 7 water by-pass hose to the diesel throttle body assembly, and slide the clamp to secure the hose.


Hide 17343D 2.INSTALL NO. 3 AIR HOSE

a.
A208800C01
2.135,0.677 2.448,0.833 0.313,0.156 10 70° 3.021,3.917 3.333,4.073 0.313,0.156 10 90° 1.625,0.49 1.938,0.646 0.313,0.156 10 *a 1.063,1.156 1.375,1.313 0.313,0.156 10 *b 2.417,3 2.729,3.156 0.313,0.156 10 *c 1.74,3.688 2.052,3.844 0.313,0.156 10 *a
*a Front
*b Left
*c Upper


Install the No. 3 air hose to the No. 2 air tube and diesel throttle body assembly.

NOTICE:

Clean the outer surface of the pipe and the inner surface of the hose before connecting the parts.



b.

Tighten the 2 hose clamps as shown in the illustration.

Torque:
6.5 N*m (66 kgf*cm, 58 in.*lbf)

HINT:

Make sure the direction of the hose clamps is asshown in the illustration.



Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 51441 6.INSTALL NO. 1 ENGINE UNDER COVER

Hide 8.PERFORM THROTTLE VALVE FULLY CLOSED POSITION LEARNING

HINT:

Be sure to turn off the ignition switch before performing this inspection.


a.

Turn the ignition switch to ON.


b.

Turn the ignition switch off and wait 30 seconds.

HINT:

The fully closed position of the diesel throttle valve is learned when the ignition switch is turned off.