1.PERFORM REGISTRATION
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
12611
4.REMOVE NO. 1 ENGINE COVER
17705
5.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17801
6.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
7.REMOVE AIR CLEANER CASE
89661
8.REMOVE ECM
Disconnect the 2 ECM connectors.
| *1 | Lock |
| *a | Push |
Raise the 2 levers while pushing the locks on the levers and disconnect the 2 ECM connectors.
After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.
Remove the 3 bolts and ECM with bracket.
Remove the 4 screws, No. 1 ECM bracket and No. 2 ECM bracket.