Home › Engine / Hybrid System › 1AD-FTV ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008729 1AD-FTV ENGINE CONTROL _0048788 CRANKSHAFT POSITION SENSOR A

1AD-FTV ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11401G 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

NOTICE:
·

When reusing the camshaft position sensor, inspect the O-ring.

·

Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.




b.
A273388
0.333,0.375 0.531,0.375 0.531,0.375 1.094,0.802 true 0.292,1.406 0.49,1.406 0.49,1.406 0.875,1.865 true 0.104,1.333 0.417,1.49 0.313,0.156 10 *1 0.135,0.302 0.448,0.458 0.313,0.156 10 *1
*1 Protrusion


Install the crankshaft position sensor with the bolt.

Torque:
8.8 N*m (90 kgf*cm, 78 in.*lbf)


c.

Install the crankshaft position sensor wire harness with the clip.

NOTICE:

Make sure the crankshaft position sensor wire harness is installed in the position shown in the illustration.



d.

Install the harness clamp bracket with the bolt.

Torque:
8.8 N*m (90 kgf*cm, 78 in.*lbf)


e.

Connect the crankshaft position sensor connector.