Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM3090E _55 Steering _008772 POWER ASSIST SYSTEMS _0049011 POWER STEERING SYSTEM D

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  CALIBRATION  


ASSIST MAP WRITING (USING THE GTS)


a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / EMPS / Utility / Signal Check.

Chassis > EMPS > Utility
Tester Display
Signal Check
50005 142 3
HINT:
·

Follow the instructions on the GTS to perform Signal Check.

·

With DTC C1581/26 output, performing Signal Check will cause the power steering ECU assembly to enter Test Mode and the assist map will be written automatically.




f.

Wait for at least 5 seconds.


g.

Check for DTCs (Click here Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

HINT:

After writing the assist map, if DTC C1581/26 is output, perform the troubleshooting procedure for DTC C1581/26 (Click here Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>C1581/26).




ASSIST MAP WRITING (USING SST CHECK WIRE)


a.
C248264C22
1.604,0.802 1.604,0.406 false 1.604,1.865 1.604,1.49 false 1.5,0.229 1.729,0.375 0.229,0.146 10 false CG 1.531,1.885 1.75,2.031 0.219,0.146 10 false TS 0.177,0.156 0.51,0.49 0.333,0.333 10 false *1
*1 DLC3


Connect the terminals correctly to avoid a malfunction.


b.

Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.

SST
09843-18040  

NOTICE:

Connect the terminals correctly to avoid a malfunction.



c.

Turn the ignition switch to ON.


d.

Wait for 5 seconds or more.


e.

Check for DTCs (Click here Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

HINT:

After writing the assist map, if DTC C1581/26 is output, perform the troubleshooting procedure for DTC C1581/26 (Click here Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>C1581/26).