Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER
RM3090E _58 Vehicle Interior _008784 METER / GAUGE / DISPLAY _0049183 COMBINATION METER A

METER / GAUGE / DISPLAY  COMBINATION METER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55412C 3.REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL

Hide 55670 4.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55411G 5.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL

Hide 83100 6.REMOVE COMBINATION METER ASSEMBLY

a.
E268658

Remove the 2 screws.


b.

Detach the 2 clips and remove the combination meter assembly.


c.
B337778

Disconnect the 2 connectors.