1.REMOVE ENGINE ASSEMBLY
25586
2.REMOVE NO. 1 MANIFOLD CONVERTER INSULATOR
25051
3.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
89425
4.REMOVE EXHAUST GAS TEMPERATURE SENSOR
If the exhaust gas temperature sensor is dropped, replace it with a new one.
Detach the exhaust gas temperature sensor connector clamp.
Using a 14 mm union nut wrench, loosen the union nut.
Remove the nut, clamp and exhaust gas temperature sensor.
89425A
5.REMOVE NO. 2 EXHAUST GAS TEMPERATURE SENSOR
If the No. 2 exhaust gas temperature sensor is dropped, replace it with a new one.
Detach the No. 2 exhaust gas temperature sensor connector clamp.
Using a 14 mm union nut wrench, remove the No. 2 exhaust gas temperature sensor.