Home › Engine / Hybrid System › 2AD-FHV EMISSION CONTROL › EXHAUST FUEL ADDITION INJECTOR
RM3090E _51 Engine / Hybrid System _008736 2AD-FHV EMISSION CONTROL _0049296 EXHAUST FUEL ADDITION INJECTOR A

2AD-FHV EMISSION CONTROL  EXHAUST FUEL ADDITION INJECTOR  INSTALLATION  


PROCEDURE

Hide 23255B 1.INSTALL FUEL INJECTOR SEAL

a.

Install a new fuel injector seal to the exhaust fuel addition injector assembly.


Hide 23710B 2.INSTALL EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

NOTICE:

If there is foreign matter on the installation surface of the exhaust fuel addition injector assembly, be sure to clean the exhaust fuel addition injector assembly before installation.


a.

Install a new gasket, the exhaust fuel addition injector assembly, the nozzle holder clamp, and the washer with the bolt.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)

HINT:
A201785C02
0.625,1.052 1.375,1.052 true 0.458,0.958 0.771,1.115 0.313,0.156 10 *1
*1 Nozzle Holder Clamp


Align the nozzle holder clamp with the cutouts of the exhaust fuel addition injector assembly as shown in the illustration.



Hide 23901E 3.INSTALL FUEL TUBE SUB-ASSEMBLY

Hide 23292A 4.INSTALL FUEL HOSE PROTECTOR

a.

Install the fuel hose protector with the bolt.

Torque:
21 N*m (209 kgf*cm, 15 ft.*lbf)


b.

Connect the exhaust fuel addition injector connector.


Hide 17801 6.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17705 7.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION