This DTC is stored when the hard disc which is built into the navigation ECU sub-assembly has an initialization malfunction or read/write errors occur more than a specified number of times.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15B8 | Harddisk Malfunction | Hard Disc malfunction | Hard disc |
| *a | Result |
Enter the "HDD Check" screen. Refer to Check Hard Disc in Operation Check.
Select "HDD Check" and check the result.
After "HDD Check" is selected, it may take a while until the result is displayed.
| Proceed to |
|---|
| "OK" is displayed |
| "OK" is not displayed |
"OK" is displayed
"OK" is not displayed
Clear the DTCs.
Recheck for DTCs and check if the same DTC is output again.
The hard disc may be malfunctioning even if DTC B15B8 is not output.
| Proceed to |
|---|
| No DTCs are output |
| DTCs are output |
No DTCs are output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTCs are output