Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2012.12–2015.10
RM3090E _54 Brake _008767 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0048751 VEHICLE STABILITY CONTROL SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  VSC Buzzer Circuit  


DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.

The combination meter assembly has a built-in buzzer.

WIRING DIAGRAM

C230884E16
5.344,1.479 6.865,1.938 1.521,0.458 10 false Skid Control ECU (Brake Actuator Assembly) 0.604,1.969 2.729,2.281 2.125,0.313 10 false Combination Meter Assembly 1.021,0.906 1.573,1.104 0.552,0.198 10 false Buzzer 0.906,2.427 3.135,2.656 2.229,0.229 10 false : CAN Communication Line

CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform zero point calibration.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM

Result:
Proceed to
DTC is not output
DTC is output (for LHD)
DTC is output (for RHD)



DTC is not output

2.PERFORM ACTIVE TEST USING GTS (BUZZER)

DTC is output (for LHD)

DTC is output (for RHD)

2.PERFORM ACTIVE TEST USING GTS (BUZZER)
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.


f.

According to the display on the GTS, perform the Active Test.


Chassis > ABS/VSC/TRC > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Buzzer meter buzzer ON/OFF Buzzer can be heard
Vehicle condition: Vehicle stopped
g.

When performing the Buzzer Active Test, check Buzzer in the Data List.


Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Buzzer Meter buzzer ON or OFF OFF: Buzzer off
ON: Buzzer on
The combination meter assembly has a built-in buzzer.
Chassis > ABS/VSC/TRC > Active Test
Active Test Display
Buzzer
Data List Display
Buzzer
50004 105 7 54
Result:
Result Proceed to
Buzzer in the Data List does not change using the Active Test A
Buzzer in the Data List turns ON/OFF using the Active Test B



A

B

3.INSPECT COMBINATION METER ASSEMBLY
3.INSPECT COMBINATION METER ASSEMBLY
a.

Inspect the combination meter.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>PROBLEM SYMPTOMS TABLE

Result:
Result
OK
NG




OK

NG

REPLACE COMBINATION METER ASSEMBLY