Home › Suspension › REAR SUSPENSION › REAR UPPER ARM
RM3090E _53 Suspension _008765 REAR SUSPENSION _0049361 REAR UPPER ARM A

REAR SUSPENSION  REAR UPPER ARM  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 48790 1.TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH

a.

Temporarily install the rear upper control arm to the rear suspension member and rear axle carrier with the 2 bolts and 2 nuts.


Hide 48790 3.TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH

a.

Using a jack and wooden block, raise the vehicle so that the rear No. 2 suspension arm assembly LH is at the standard vehicle height to apply load to the rear suspension.


b.

Tighten the 2 bolts and 2 nuts of the upper control arm.

Torque:
90 N*m (918 kgf*cm, 66 ft.*lbf)

NOTICE:

Since a stopper nut is used, tighten the bolt.



Hide 89516D 4.CONNECT SKID CONTROL SENSOR WIRE LH

a.

Connect the skid control sensor wire to the rear upper control arm with the 2 nuts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 5.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 6.INSPECT AND ADJUST REAR WHEEL ALIGNMENT