Home › Engine / Hybrid System › 2AR-FE STARTING › STARTER(for 1.7 kW Type)
RM3090E _51 Engine / Hybrid System _008402 2AR-FE STARTING _0049375 STARTER(for 1.7 kW Type) A

2AR-FE STARTING  STARTER(for 1.7 kW Type)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

Hide 74404A 4.REMOVE BATTERY CLAMP SUB-ASSEMBLY

a.
A296163

Remove the bolt and loosen the nut.


b.

Detach the 2 wire harness clamps.


c.

Detach the hook of the battery clamp sub-assembly from the front battery bracket, and then remove the battery clamp sub-assembly.


Hide 28899 5.REMOVE BATTERY INSULATOR

Hide 28800 6.REMOVE BATTERY

Hide 74431 7.REMOVE BATTERY TRAY

Hide 74411B 8.REMOVE FRONT BATTERY BRACKET

A296164

a.

Remove the 4 bolts and front battery bracket.


Hide 74414B 9.REMOVE BATTERY BRACKET REINFORCEMENT

A296165

a.

Remove the 2 bolts and battery bracket reinforcement.


Hide 28100 10.REMOVE STARTER ASSEMBLY

A296166

a.

Disconnect the starter connector and remove the terminal cap.


b.

Remove the nut and disconnect the starter wire.


c.
A194738

Remove the 2 bolts and starter assembly.