Home › Engine / Hybrid System › 2AR-FE STARTING › STARTER(for 1.7 kW Type)
RM3090E _51 Engine / Hybrid System _008402 2AR-FE STARTING _0049375 STARTER(for 1.7 kW Type) A

2AR-FE STARTING  STARTER(for 1.7 kW Type)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Install the starter assembly with the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


b.

Connect the starter wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Connect the starter connector.


d.

Install the terminal cap.


Hide 74414B 2.INSTALL BATTERY BRACKET REINFORCEMENT

a.

Install the battery bracket reinforcement with the 2 bolts.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


Hide 74411B 3.INSTALL FRONT BATTERY BRACKET

a.

Install the front battery bracket with the 4 bolts.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


Hide 74431 4.INSTALL BATTERY TRAY

Hide 28800 5.INSTALL BATTERY

Hide 28899 6.INSTALL BATTERY INSULATOR

Hide 74404A 7.INSTALL BATTERY CLAMP SUB-ASSEMBLY

a.
A296163C01
1.396,1.969 1.667,2.042 1.667,2.042 1.865,2.042 true 2.01,0.292 2.417,0.292 true 1.917,1.958 2.229,2.115 0.313,0.156 10 *1 2.458,0.229 2.771,0.385 0.313,0.156 10 *2
*1 Bolt
*2 Nut


Attach the hook of the battery clamp sub-assembly to the front battery bracket.


b.

Partially tighten the nut and temporarily install the bolt.


c.

Adjust the battery clamp position.


d.

Tighten the nut and bolt.

Torque:
for bolt : 17 N*m (173 kgf*cm, 13 ft.*lbf)
for nut : 4.9 N*m (50 kgf*cm, 43 in.*lbf)


e.

Attach the 2 wire harness clamps.


Hide 8.CONNECT CABLE TO POSITIVE BATTERY TERMINAL

a.

Connect the cable to the positive (+) battery terminal.

Torque:
5.4 N*m (55 kgf*cm, 4 ft.*lbf)


Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION