Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM
RM3090E _58 Vehicle Interior _008690 THEFT DETERRENT / KEYLESS ENTRY _0048165 THEFT DETERRENT SYSTEM C

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  B2768  Tilt Sensor Internal Circuit Malfunction  


DESCRIPTION

This DTC is stored when one of the following occurs: 1) tilt sensor (yaw rate sensor assembly) power supply malfunction; 2) tilt sensor (yaw rate sensor assembly) open malfunction; or 3) EEPROM malfunction.

DTC No. Detection Item DTC Detection Condition Trouble Area
B2768 Tilt Sensor Internal Circuit Malfunction
If one of the following is detected:
·

Tilt sensor (yaw rate sensor assembly) power supply malfunction

·

Tilt sensor (yaw rate sensor) open malfunction

·

EEPROM malfunction


·

Tilt sensor (yaw rate sensor assembly)

·

Main body ECU (multiplex network body ECU)



CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

·

When replacing the main body ECU (multiplex network body ECU), make sure to replace it with a new one.



PROCEDURE

1.CHECK FOR DTC
a.

Clear the DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Clear DTCs
50002 123

b.

Turn the ignition switch to ON, then off.


c.

Set the theft deterrent system to "ARMED STATE".


d.

Check that the security indicator changes from illuminated to blinking.


e.

Set the theft deterrent system to "DISARMED STATE".


f.

Check for DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Trouble Codes
50001 123

Result:
Proceed to
DTC B2768 is not output
DTC B2768 is output



DTC B2768 is not output

DTC B2768 is output

2.REPLACE TILT SENSOR (YAW RATE SENSOR ASSEMBLY)
2.REPLACE TILT SENSOR (YAW RATE SENSOR ASSEMBLY)
a.

Temporarily replace the tilt sensor (yaw rate sensor assembly) with a new or normally functioning one.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>TILT SENSOR>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC
a.

Clear the DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Clear DTCs
50002 123

b.

Turn the ignition switch to ON, then off.


c.

Set the theft deterrent system to "ARMED STATE".


d.

Check that the security indicator changes from illuminated to blinking.


e.

Set the theft deterrent system to "DISARMED STATE".


f.

Check for DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Trouble Codes
50001 123

Result:
Proceed to
DTC B2768 is not output
DTC B2768 is output



DTC B2768 is not output

END (TILT SENSOR [YAW RATE SENSOR ASSEMBLY] WAS DEFECTIVE)

DTC B2768 is output

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)