Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › TILT SENSOR
RM3090E _58 Vehicle Interior _008690 THEFT DETERRENT / KEYLESS ENTRY _0055089 TILT SENSOR A

THEFT DETERRENT / KEYLESS ENTRY  TILT SENSOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE FRONT SEAT ASSEMBLY LH

Hide 62112 4.REMOVE COWL SIDE TRIM BOARD LH

Hide 67914B 5.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 67918E 6.REMOVE REAR DOOR SCUFF PLATE LH

Hide 73233 7.REMOVE OUTER LAP BELT ANCHOR COVER

Hide 62414A 8.REMOVE LOWER CENTER PILLAR GARNISH LH

Hide 89189B 9.REMOVE YAW RATE SENSOR BRACKET

a.

Partially remove the floor carpet.


b.
E266957

Remove the bolt.


c.

Detach the guide and remove the yaw rate sensor bracket.


Hide 89180 10.REMOVE YAW RATE SENSOR ASSEMBLY

a.
E266958

Disconnect the connector.


b.

Remove the 2 bolts and yaw rate sensor assembly.

NOTICE:

Do not remove the yaw rate sensor assembly sensor from the bracket.