Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY
RM3090E _55 Steering _008773 STEERING COLUMN _0049531 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  REASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 80960 1.INSTALL POWER STEERING MOTOR ASSEMBLY

a.

Apply grease to the spline part of the electric power steering column sub-assembly.


b.

Install a new O-ring to the power steering motor assembly.


c.
C275628

Install the power steering motor assembly with the new 2 bolts.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


d.

Place new heat resistant tape.

NOTICE:

As heat from the power steering motor assembly may generate smoke, use heat resistant tape (resistant to 100°C (212°F) or higher).



Hide 89650 2.INSTALL POWER STEERING ECU ASSEMBLY

Hide 3.INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)

a.
C280248

Turn the ignition switch to ACC.


b.

Install the ignition switch lock cylinder assembly into the upper steering column bracket assembly.


c.

Make sure that the ignition switch lock cylinder assembly is securely fixed onto the ignition switch lock cylinder assembly.


Hide 84052 4.INSTALL UNLOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)

a.
C233276

Attach the 2 claws to install the unlock warning switch assembly onto the upper steering column bracket assembly.

HINT:

Slide the unlock warning switch assembly in the direction shown by the arrow in the illustration to install it.



Hide 85432 5.INSTALL KEY INTERLOCK SOLENOID (for Automatic Transaxle and CVT)

a.
C280247

Install the key interlock solenoid onto the upper steering column bracket assembly with the screw.


Hide 84450 6.INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (w/o Entry and Start System)

Hide 89782 7.INSTALL TRANSPONDER KEY COIL (w/o Entry and Start System)

Hide 45020A 8.INSTALL STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System)

HINT:

When replacing the steering lock actuator assembly, refer to the Service Bulletin.


a.

Temporarily install the steering lock actuator assembly with 2 new tapered-head bolts.

NOTICE:

Be sure to use 2 new tapered-head bolts.



b.
C275672C01
0.833,1.813 1.25,1.396 true 1.854,2.656 2.073,2.01 true 0.719,1.792 0.875,1.99 0.156,0.198 10 2 1.781,2.667 1.938,2.865 0.156,0.198 10 1

Tighten the 2 tapered-head bolts until the bolt head breaks off.

HINT:

Tighten the nuts in the order shown in the illustration.



Hide 45020A 9.INSTALL STEERING LOCK ACTUATOR ASSEMBLY (w/o Entry and Start System)

HINT:

Refer to "INSTALL STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System)"