Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
89650
1.INSTALL POWER STEERING ECU ASSEMBLY
Install the power steering ECU assembly with 2 new bolts.
Install 3 new terminal bolts.
Connect the 2 connectors and 2 harness clamps, and install a new ECU wire sub-assembly to the power steering ECU.
Install 2 new power steering ECU protectors to the power steering ECU assembly.
4520A
2.INSTALL ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY
3.INSTALL UPPER INSTRUMENT PANEL
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
5.CHECK SRS WARNING LIGHT
w/ Occupant Classification System: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/ Occupant Classification System)>DIAGNOSIS SYSTEM
w/o Occupant Classification System: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/o Occupant Classification System)>DIAGNOSIS SYSTEM
6. ASSIST MAP WRITING