Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP(for 3ZR-FAE)
RM3090E _54 Brake _008768 BRAKE SYSTEM (OTHER) _0049564 VACUUM PUMP(for 3ZR-FAE) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 3ZR-FAE)  INSTALLATION  


PROCEDURE

Hide 29300 1.INSTALL VACUUM PUMP ASSEMBLY

a.
C169250C02
0.631,1.128 0.797,1.273 0.167,0.145 10 *2 1.364,1.789 1.515,1.933 0.151,0.145 10 *1 1.966,1.63 1.966,1.863 1.966,1.863 1.545,1.863 false 1.294,1.524 1.294,1.211 1.294,1.211 0.831,1.211 false
*1 No. 2 O-ring
*2 No. 3 O-ring


Apply engine oil to the No. 2 and No. 3 O-rings on the vacuum pump assembly.

NOTICE:

When removing and installing the vacuum pump assembly, replace the No. 2 and No. 3 O-rings with new ones.



b.

Apply engine oil to the inner surface of the installation hole.


c.
C169249

Install the vacuum pump assembly so that the oil pipe engages with the hole of the camshaft and the coupling teeth with the grooves on the camshaft tip.

NOTICE:
·

Ensure that the vacuum pump assembly is installed securely.

·

Be careful not to pinch the O-ring.



HINT:

Apply engine oil to the O-ring.



d.
C278625E01
0.885,2.354 1.042,2.552 0.156,0.198 10 A 3.031,2.729 3.188,2.927 0.156,0.198 10 B 3.219,2.104 3.354,2.313 0.135,0.208 10 B

Install the vacuum pump assembly with the 3 bolts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)

NOTICE:
·

After installation, check that there are no gaps between the matching surfaces and that the vacuum pump assembly is not installed at an angle.

·

As 2 different lengths of bolts are used, make sure to check the proper installation positions before installing them.

·

After tightening the bolts, ensure that the contact surface of the vacuum pump assembly is flush with the cylinder head.



HINT:
·

Bolt length

Bolt A: 25 mm

Bolt B: 45 mm




Hide 44774 2.CONNECT UNION TO CONNECTOR TUBE HOSE

a.
C278626

Connect the vacuum hose and slide the clamp to secure it.


Hide 29300 3.INSPECT VACUUM PUMP OPERATION

Hide 5.INSTALL AIR CLEANER CASE SUB-ASSEMBLY

Hide 17705 6.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

Hide 11212 7.INSTALL NO. 2 CYLINDER HEAD COVER