The vacuum pump assembly is listed as one of the 200000 km (124000 mile) maintenance parts. Make sure to disassemble and inspect it every 200000 km (124000 miles) and replace parts as necessary.
11212
1.REMOVE NO. 2 CYLINDER HEAD COVER
17705
2.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
3.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
4.DISCONNECT ENGINE WIRE
44774
5.DISCONNECT UNION TO CONNECTOR TUBE HOSE
Slide the clip and disconnect the hose.
29300
6.REMOVE VACUUM PUMP ASSEMBLY
Remove the 3 bolts and vacuum pump from the engine assembly.
As 2 different lengths of bolts are used, make sure to make a note of the installation positions.
| *1 | No. 2 O-ring |
| *2 | No. 3 O-ring |
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, remove the No. 2 and No. 3 O-rings from the vacuum pump.
Do not damage the groove.